Yetter 2967-180 Residue Manager for 2959 Offset Injection Manuel d'utilisateur

2967-180 RESIDUE MANAGER FOR 2959 OFFSET INJECTION COULTER OPERATOR’S / INSTRUCTION MANUAL W/ PARTS IDENTIFICATION Y

10OPERATION CAUTION: Where rocks are present the residue manager should be set in the “float” position, not locked down. STEP 1. Adjust the resi

11 MAINTENANCE BEARING ASSEMBLY AND LUBRICATION Practice Safety Understand and practice safe service procedures before doing work. Follow ALL the

12MAINTENANCE NOTE: Be certain to align the grease fitting with the slot in the wheel and the hubcap so that the grease can flow freely. IMPORTANT

13MAINTENANCE Grease must fill this Hubcap cavity.

14MAINTENANCE Lubrication CAUTION: To help prevent serious injury or death to you or others caused by unexpected movement, service machine on a leve

15MAINTENANCE Lubrication Symbols Lubricate with grease at hourly interval indicated on symbol. Lubrication Intervals IMPORTANT: The recommended

16MAINTENANCE Storing the Equipment Store the machine in an area away from human activity Store machine in RAISED position. Install service locks

17PARTS IDENTIFICATION

18TROUBLESHOOTING Figure A. (Correct) Figure B. (Incorrect) Figure A. – The planter frame is 20” off the ground. To ensure this, visually check

19NOTES

2You’ve just joined an exclusive but rapidly growing club. For our part, we want to welcome you to the group and thank you for buying a Yetter prod

Our name Is getting known Just a few years ago, Yetter products were sold primarily to the Midwest only. Then we embarked on a program of expan

3TABLE OF CONTENTS FOREWORD ... 1 TABLE OF

4SAFETY A brief description of signal words that may be used in this manual: CAUTION: Used as a general reminder of good safety practices or to dir

5 ASSEMBLY INSTRUCTIONS GENERAL INFORMATION Examine all equipment carefully for damage or shortages. Lubricate all bearings and moving parts as a

6ASSEMBLY INSTRUCTIONS WARNING: NEVER WORK UNDER THE EQUIPMENT WHILE IN A RAISED POSITION WITHOUT USING SAFETY LOCK UPS. FAILURE TO DO SO MAY LE

7ASSEMBLY INSTRUCTIONS STEP 2. Attach the 2967-270 R.M. arm to the coulter arm using the 5/8” x 9” bolt, 4) 5/8” flat washers, 2) pivot bushings

8ASSEMBLY INSTRUCTIONS STEP 4. Attach the 2967-181 Quick Adjust Assembly to the residue manager arm using 2) 3/8” x 3 1/4” bolts, 2) spacer bus

9ASSEMBLY INSTRUCTIONS STEP 5. CONT… NOTE: During assembly be sure to align the grease-fitting hole in all the components to assure proper